Basic requirements for sweater stitching
Here are some things to note when sewing a sweater: 1. Adopt the correct method of acupuncture: Multi-purpose single-line chain-locking steps for forming sweaters. The tailoring of the sweater is mainly based on the overlock. Stitch zippers and logos with flat stitching steps. 2. Do you need to sew your eyes: To form a sweater, the position of the mouth should be hit by the eye or the hand. 3. Whether the opposite side, the opposite flower, and the opposite seam: In the shaping of sweaters, these are unwritten habits, there are sides (辫) to the opposite side, there are flowers to be right, there is a right thing to do, unless it is impossible. 4, the tightness control of the suture: Pay attention to the tight stitching of the over-the-top part of the over-the-top garment. It is very likely that you will hear the cracking sound when you wear it! 5, the ratio of dissolution: It is often necessary to sew two kinds of elastic and different lengths of cloth together, but pay attention to the distribution of the proportion of the mixture! To be even, if there are wrinkles or special requirements, the distribution ratio should be mastered. 6, the collision handling: The shredded coil is stitched with a hand stitch, called a collision, and the position of the dead end of the two sides is sewn together in the form of a dark seam, which is called picking; the seam of the eye, the opposite side, the pick or the collision is often the grade of the sweater. An important indicator.
With the continuous development of society, the advancement of
science and technology, the types and styles of photo frames are also
increasing. The most popular ones are wooden photo frames and plastic photo
frames. Wooden frames are made of various kinds of wood, commonly used are
Paulownia, white wood, Phoebe, pine, etc., while the market structure of modern
minimalist wooden frame is mainly flat wood, wood frame is mainly used for
decorative materials, Outer packaging. Plastic Photo Frame is a kind of organic
matter, the weight is very small, so that it can be made into a photo frame,
more convenient to carry,
Plastic frame is divided into PS foam and PVC, PP and other
materials injection molding. PVC, PP materials, is a kind of mold forming, this
material is light, good toughness is better than PS, many styles and processes
are PS can not be achieved, and the price is relatively low compared to PS; PS
frame material, It is a kind of frame material which is heated and molded by PS
filler at high temperature and then attached with film on the surface. This
material is light, tough, good strength and less prone to break. Be sure to be
careful when shipping.
Photo Frame Photo Frame,Jigsaw Puzzle Frames,Puzzle Picture Frames,Puzzle Photo Frame Donguan Shengrong Industry Co,.tld , http://www.myheattransfer.com